Filter
Sort:
Show:
BECKHOFF Bus Terminal, KL1809

BECKHOFF Bus Terminal, KL1809

  • input specification type 1/3
  • no bouncing due to mechanical switches thanks to 3 ms input filter
  • tool-free connection by direct plug-in technology for solid wire conductors
  • space-saving use in the control cabinet
  • direct connection of multi-channel sensors in 1-wire connection technology in the smallest space
  • increased packing density with 16 connection points in the housing of a 12 mm terminal bloc
Read more
Baumer Retro-reflective Sensors FPDM 12P5101/S35A

Baumer Retro-reflective Sensors FPDM 12P5101/S35A

With retro-reflective sensors, the transmitter and receiver are located in one housing and combined with a prismatic reflector. The reflector reflects the emitted light beam and if the light is interrupted by an object, the sensor switches.
Read more
AECO VIBRATION LEVEL CONTROLS

AECO VIBRATION LEVEL CONTROLS

Electrical data: Connection terminals: 0.14 ÷ 2.5 mm2 (AWG 26 ÷ 14) Cable entry:Cable gland: M20x1.5 with cable sheath diameter 6÷12mm CONDUIT: NPTx½ o NPT3/4 Output activation delay: Rods free → Rods covered: c.a. 1 sec Rods covered → Rods free c.a. 1... 2 sec Detection fuctions FSH/FSL: Settable on the circuit with selector switch Vibration frequency: [Hz] 200 c.a. Over voltage category: II Pollution degree: 2 (inside housing) Operative Conditions: Ambient temperature: [°C] -40 ÷ +60 Process temperature-Tc: [°C] -40 ÷ +150 Ventilation:Ventilation is not required Min. powder density: [g/l] Setting A : c.a. 150 - Setting B : c.a. 30 Features of bulk material: No strong tendency to cake or deposit. Max grain size 8 mm Max. mechanical load: [N] 500 laterally on vibrant rods Max. process pressure: [Bar] 16 Vibration: c.a. 200 Relative humidity: 0 ÷ 100%, suitable for outdoor use Altitude: [m] max 2.000
Read more
BECKHOFF Communication Module EK1100 EtherCAT Coupler

BECKHOFF Communication Module EK1100 EtherCAT Coupler

The EK1100 EtherCAT Coupler is the link between the EtherCAT protocol at the fieldbus level and the EtherCAT Terminals. The coupler converts the passing telegrams from Ethernet 100BASE-TX to E-bus signal representation. A station consists of a coupler and any number of EtherCAT Terminals that are automatically detected and individually displayed in the process image.
Read more

Filter Products

Categories