Filter

Showing all 4 resultsSorted by latest

Sort:
Show:
KOYO Rotary Encoder TRD-J1000-RZ

KOYO Rotary Encoder TRD-J1000-RZ

φ50 Incremental Type

-   Long service-life with a φ50 mm miniature case and φ8 mm- thick shaft.

  • Realizes 1,024 pulses with a metal slit board that resists vibrations and impacts.

-   Wide power range of 4.75 to 30 V DC.

  • Totem-pole output suitable for cable extension.
Read more
AECO VIBRATION LEVEL CONTROLS

AECO VIBRATION LEVEL CONTROLS

Electrical data: Connection terminals: 0.14 ÷ 2.5 mm2 (AWG 26 ÷ 14) Cable entry:Cable gland: M20x1.5 with cable sheath diameter 6÷12mm CONDUIT: NPTx½ o NPT3/4 Output activation delay: Rods free → Rods covered: c.a. 1 sec Rods covered → Rods free c.a. 1... 2 sec Detection fuctions FSH/FSL: Settable on the circuit with selector switch Vibration frequency: [Hz] 200 c.a. Over voltage category: II Pollution degree: 2 (inside housing) Operative Conditions: Ambient temperature: [°C] -40 ÷ +60 Process temperature-Tc: [°C] -40 ÷ +150 Ventilation:Ventilation is not required Min. powder density: [g/l] Setting A : c.a. 150 - Setting B : c.a. 30 Features of bulk material: No strong tendency to cake or deposit. Max grain size 8 mm Max. mechanical load: [N] 500 laterally on vibrant rods Max. process pressure: [Bar] 16 Vibration: c.a. 200 Relative humidity: 0 ÷ 100%, suitable for outdoor use Altitude: [m] max 2.000
Read more
ACS CONTROL SYSTEM LIMIT SWITCH GWA-250-U0

ACS CONTROL SYSTEM LIMIT SWITCH GWA-250-U0

The GWA-250-U0 dual limit value switch enables the parallel configuration of up to two switching  levels for continuous measurements without the installation of extra measurement equipment. ♦ The key coding switch allows for the simplest switching point change. ♦ Switchable input. ♦ Powering integrated converters.
Read more
DUNGS Actuator DriveCP-9302-702

DUNGS Actuator DriveCP-9302-702

The CP-9302-702 electronic actuator drive processes a variable input signal from a controller to provide proportional control of an electric actuator. The CP-930-702 is preset for current input (4 - 20 mA) and has additional wiring for connection to an override switch for applications requiring an external override of the input signal. The CP-9302-702 is equipped with built-in jumpers and adjustable potentiometers, so that the type of input signal, deadband, input span, and start point may be readjusted in the field when necessary.
Read more

Filter Products

Categories